Subaru IMPREZA 2004 Service Manual page 51

3) Using the height gauge, measure "C1" and "C2"
shown in the figure.
C2
C1
(B)
(A)
(A) 3rd drive gear
(B) 4th drive gear
(1) Shift the 3rd-4th sleeve to 4th gear side,
then press up to the stopper and measure "C2".
(A)
(A) 4th drive gear
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
• Turn dial (2) to set the indicator to edge surface
of sleeve 4th side.
• Perform the measuring procedure with two peo-
ple, and measure the sleeve lifted up straight.
Shifter Fork and Rod
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining center val-
ue as measurement value.
(2) Set the height gauge indicator upside down.
MT-00707
(3) Shift the 3rd-4th sleeve to 3rd drive gear
side, then press down to the stopper and mea-
sure "C1".
MT-00708
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 3rd side.
6MT-119
MANUAL TRANSMISSION AND DIFFERENTIAL
(A)
(A) Indicator
(A)
(A) 3rd drive gear
(2)
(1)
MT-00585
MT-00710
MT-00711