Subaru IMPREZA 2004 Service Manual page 19

9) Using the ST, remove each parts.
ST 18754AA000 REMOVER
ST
(E)
ST
(A) 2nd bush
(B) 1st-2nd hub
(C) Outer baulk ring
(D) 1st synchro cone
(E) Inner baulk ring
(F) 1st driven gear
(G) 1st needle bearing
D: ASSEMBLY
NOTE:
Replace the following parts as a set.
• Sleeve and hub
• Outer baulk ring, 1st synchro cone, inner baulk
ring
• Outer baulk ring, 2nd synchro cone, inner baulk
ring
1) Sufficiently apply gear oil to the drive shaft, 1st
needle bearing and inner periphery of 1st driven
gear.
Driven Gear Assembly
2) Install the 1st needle bearing.
3) Install the 1st driven gear to driven shaft.
(A)
(B)
(C)
(D)
(F)
(G)
MT-00594
4) Install the inner baulk ring.
5) Align protrusion portions of the 1st synchro cone
to the holes of 1st drive gear to install.
6MT-87
MANUAL TRANSMISSION AND DIFFERENTIAL
MT-00595
MT-00596
MT-00597
MT-00598