Set Monitoring Items To Be Shown As A Trend Plot - YASKAWA CIPR-CR70A Series Technical Manual

■

Set Monitoring Items to be Shown as a Trend Plot

You must set the items in this figure to display as a trend plot.
A - Monitor Parameter 1 (set with
[Custom Monitor 1])
B - Monitor Parameter 2 (set with
[Custom Monitor 2])
C - Trend Plot 2 Scale Maximum/
Minimum Value
Select Monitor Items to Show as a Trend Plot
The procedure in this section shows how to show the frequency reference monitor as a trend plot.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push (Menu).
3.
Push or to select [Monitors], then push
4.
Push or to select [Trend Plot], then push
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
D - Trend Plot Time Scale
E - Trend Plot 1 Scale Maximum/
Minimum Value
, push (Back) to show [Home] on
.
3 Startup Procedure and Test Run
.
(Setup).
131