Table of Contents
Advertisement
A - Cutaway section
Note:
• Different drive models have different wiring cover shapes.
• Remove only the areas from the wiring cover that apply to the wired terminal. The drive will not keep its IP20 protective level
if areas that do not apply to the wired terminal are removed.
• Tightly hold the cutaway section when removing pieces of the cutaway section. Pieces of the cutaway section can fly out
and cause injury.
• Remove sharp edges from the wiring cover cutaway section to prevent damage to the wires.
• The drive might not keep its IP20 protective level if wires other than those specified by Yaskawa are used, even if the wiring
cover is used correctly. Contact Yaskawa or your nearest sales representative for more information.
• If the recommended gauge for the electrical wires are used, the wiring cover of the main circuit power input terminal and the
drive output terminal do not need to be attached. Attach the wiring cover when using the applicable gauge for electrical
wires.
6.
Attach the wiring cover and terminal block cover to their initial positions and tighten the screws on the
terminal block cover.
7.
Put the terminal cover back in its initial position.
◆
Control Circuit Wiring
This section gives information about wiring the control circuit.
■
Control Circuit Connection Diagram
Wire the drive control circuit as shown in the following diagram.
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
A
Figure 2.100 Clip the Cutaway Section of the Wiring Cover
Figure 2.101 Reattach the Wiring Cover
2 Mechanical & Electrical Installation
B
B
B - Use a diagonal-cutting pliers to
clip this area.
85
Advertisement
Table of Contents
