IBM BladeCenter PN41 Problem Determination And Service Manual page 59

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, Type 3020," on page 23 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
ID Message
5552 Flow Control Enabled to
RECEIVE - Network
5553 Flow Control Enabled to
TRANSMIT and RECEIVE -
Network
5554 Port Attribute Change -
Hardware
6000 Capture Events - Software
7150 System Monitoring -
Software
7298 Advanced management
module Failed - Hardware
7299 Blade Failed - Hardware
When/why it
Severity Occured
Informational Operator
configured Flow
Control to
Receive Only for
the specified port.
Informational Operator
configured Flow
Control to
Transmit and
Receive for the
specified port.
Informational Operator has
changed an
attribute of the
specified port.
Informational Information sent
by the CPOS
application as
designed.
Minor CPOS has lost
communication
with the advanced
management
module.
Critical BladeCenter unit
advanced
management
module failed.
Critical CPOS is no
longer under
control of the
DPPM. Possible
reasons include
the DPI blade
was unbound or
the DPPM power
was turned off.
Action
Message is for informational purposes only.
Message is for informational purposes only.
Message is for informational purposes only.
Message is for informational purposes only
Message is for informational purposes only.
See the BladeCenter unit advanced
management module documentation for
additional information.
1. Make sure that the control network is
running.
2. Make sure the DPI blade is receiving
power.
3. Check the binding parameters.
4. Turn off the DPI blade. Turn on the DPI
blade.
Chapter 5. Diagnostics
47