server, DPI blade, or filler. Do not operate a BladeCenter H or HT unit for
more than 1 minute without a blade server, DPI blade, or filler in each blade
bay.
3. Make sure that the release handles on the DPI blade are in the open position
(perpendicular to the DPI blade).
4. Slide the DPI blade into the blade bay until it stops.
5. Push the release handles on the front of the DPI blade to the closed position.
6. Turn on the DPI blade. See "Turning on the DPI blade" on page 5 for more
information.
7. Make sure that the power-on LED on the DPI blade control panel is lit
continuously, indicating that the DPI blade is receiving power and is turned on.
8. (Optional) Write identifying information on one of the labels that come with the
BladeCenter unit and place the label on the BladeCenter unit bezel. See the
documentation for your BladeCenter unit for information about the label
placement.
Important: Do not place the label on the DPI blade or in any way block the
ventilation holes on the DPI blade.
Chapter 4. Removing and replacing DPI blade components
29