Plugging In/Turning On The Printer - Konica Minolta Magicolor 3300 Installation Manual

Konica minolta magicolor 3300: installation guide
Hide thumbs Also See for Magicolor 3300:
Table of Contents

Advertisement

Plugging in/Turning on the Printer

1
Make sure the printer is turned off.
2
Plug the printer power cord into the
printer and into a dedicated, grounded,
surge-protected electrical outlet.
Attention
Do not overload the outlet.
3
Turn on the printer.
In compliance with UL guidelines,
"The appliance inlet is consid-
ered to be the main disconnect
device."
After approximately a 6-minute
warmup (assuming normal temperature
and humidity), your printer prints a
startup page and displays "IDLE" on the message window.
This 6-minute warmup happens only when a new imaging unit
has been installed. The normal warmup time when the printer is
turned on is approximately 1.5 minutes.
If "IDLE" is not displayed in the message window after the printer is
turned on and warmed up, recheck the setup. If the startup page doesn't
print or the print quality is not good, skip ahead to "Troubleshooting" on
page 24.
The printer automatically switches to power-saving (energy-saving) mode
after 1 hour of inactivity. You can change the number of minutes before the
printer switches to power-saving mode in the Administration/Engine/Energy
Saver menu.
Attention
Never turn the power off while the printer is receiving data or printing.
Plugging in/Turning on the Printer
15

Advertisement

Table of Contents
loading

Table of Contents