Installing Accessories; Plugging In/Turning On The Printer - Konica Minolta Magicolor 7300 Installation Manual

Installing Accessories

Attention
Always turn off and unplug the printer while installing accessories.
If you purchased any additional printer accessories (such as an optional
lower feeder unit, duplex unit, or additional memory), then install them now. If
installation instructions are included with the accessory, follow them. If not,
instructions are included in the User's Guide on the Documentation CD-ROM.

Plugging in/Turning on the Printer

1
Make sure the printer is turned off.
2
Plug the printer power cord into the printer
and into a dedicated, grounded,
surge-protected electrical outlet.
In compliance with UL guidelines,
"The appliance inlet is considered to
be the main disconnect device."
3
Turn on the printer.
After approximately 100 seconds, READY/
MAGICOLOR 7300 appears in the message
window. A start page prints.
If READY/MAGICOLOR 7300 is not displayed
in the message window, recheck the setup.
Attention
Never turn off or unplug the printer while it is receiving data, printing, or
performing its automatic adjustments while it is in the Energy Saver
mode. Before turning off the printer, check that the printer is 'IDLE'.
The printer automatically switches to power-saving (Energy Saver) mode
after 30 minutes of inactivity. You can change the number of minutes in the
SYS DEFAULT/ENERGY SAVER/SLEEP TIMER menu.
Installing Accessories
27