Preparing The Toner Cartridges - Konica Minolta Magicolor 3300 Installation Manual

Preparing the Toner Cartridges

Your printer uses four toner cartridges: black, yellow,
magenta, and cyan. They are already installed in the
printer, but you must prepare them for use.
For a list of toner life expectancies and toner replacement
instructions, refer to chapter 1, "Replacing Consumables,"
in the User's Guide (on the Documentation CD-ROM).
The toner is nontoxic. If you get toner on your hands, wash them in cool water
and mild neutral detergent. If you get toner on your clothes, lightly dust them
off as much as possible. If some toner remains on your clothes, use cool, not
hot water, to rinse the toner off, provided your clothing is washable.
WARNING!
If you get toner in your eyes, wash it out immediately with cool water
and consult a doctor. Material Safety Data Sheets (MSDS) information
can be found at printer.konicaminolta.net/support (click on Answer
Base).
1
Remove the printer's top cover.
2
Pull the toner seal of the black toner
cartridge straight up.
Attention
Pulling the seal to the front or side
may damage the cartridge.
If the toner seal didn't pull completely
out because it was pulled with too
much force or it was not pulled straight up, call Technical Support. Refer
to the Service & Support Guide (on the Documentation CD-ROM) or
www.konicaminolta.net/printer/ to find the office nearest you.
3
Repeat step 2 to remove the toner seals from the other three toner
cartridges.
4
Replace the top cover.
10 Setting up Your Printer