Installing The Print Heads And The Ink Tanks - Sharp AJ-6110 Setup And Operation Manual

INSTALLING THE PRINT HEADS AND THE INK
TANKS
Installing the Print Heads
Make sure that the scan head locking switch is released.
1
Refer to step 3 of "UNPACKING", see page 10.
Make sure that the power is on.
2
For the location of the "POWER" button (
Set A4 sized paper in the tray by following steps shown in
3
"LOADING PAPER" on page 24.
Turn the front cover locking knob with one hand and lift the
4
front cover with the other hand, while keeping the knob in the
unlocked position.
Front cover
Keep the front cover open securely while installing print heads and ink tanks. You may
get your hand caught between the body and the front cover of the unit if you install
them with the front cover half open as shown in the illustration marked with an "X".
Downloaded from: http://www.usersmanualguide.com/
During ink tank replacement, if the cover is left open for more than 8 minutes,
the carriage will automatically return to its home position. To move the carriage
to the centre position again, close the front cover and then open it again.
This section describes how to install the print heads and ink tanks when you install
them for the first time after purchasing this unit. Refer to "THE INK TANK" (See page
64) or "THE PRINT HEAD" (See page 66) when they need to be changed.
) (See page 40).
Front cover
locking knob
Do not move the
carriage manually by
force.
15