Table of Contents
Advertisement
Changing the print head
Even after cleaning and aligning the print head, if copy quality remains poor, you have to
change the print head. Follow the steps below to change the print head.
Make sure that the power is on.
1
Open the front cover. (See page 15)
2
Open the maintenance cover. (See page 16)
3
Raise the print head latch. (See page 16)
4
Remove the old black or colour print head with the ink tank still
5
inserted.
lift it straight up to remove.
Remove the new print head from its protective case. (See page 16)
6
Insert the new print head. (See page 16)
7
Lower the print head latch. (See page 17)
8
Remove the ink tank(s) from the old print head (See page 64) and
9
insert them into the newly inserted print head (See page 18).
Close the maintenance cover. (See page 18)
10
Close the front cover. (See page 18)
11
If a message appears warning you that any of the ink tanks are not installed
correctly, return to step 2 and follow the procedures again.
Downloaded from:
http://www.usersmanualguide.com/
THE PRINT HEAD
67
Advertisement
Table of Contents
