Table of Contents
Advertisement
LOADING THE BYPASS TRAY WITH PAPER
(For printing only)
When loading an envelope
Open the bypass tray until it reaches position 2 (the tray has two stop positions),
set the paper knob to the "Thick Paper (
Load the envelope print side up with the flap to the right, and position against the
right edge of the tray as shown bellow. Refer to "Notes for loading envelopes" on
page 25.
(For printing only)
When loading banner paper
Open the bypass tray until it reaches position 2, and set the paper along the right
side edge of the tray.
Load the paper whose size corresponds to the size you select for the "Paper Size".
If you set different size of the paper into the tray, you may fail to print or copy
successfully.
30
Downloaded from:
http://www.usersmanualguide.com/
Maximum 5 sheets of banner paper can be used.
When printing onto banner paper, be sure to use an application software
supporting banner paper.
The paper knob should always be set to the "Normal Paper (
while printing on thick paper.
)"setting.
Position 1
Position 2
)" setting except
Advertisement
Table of Contents
