BMW 2 COUPE 2023 Series Owner's Manual page 98

CONTROLS
Buckling the seat belt
1. Guide the seat belt slowly over shoulder
and hip to put it on.
2. Insert the buckle tongue into the seat belt
buckle. The seat belt buckle must engage
audibly.
To ease accessibility to the seat belt buckle, an
adjustable slider is available on the belt to help
position the buckle when not in use.
Unbuckling the seat belt
1. Hold down the seat belt firmly.
2. Press the red button in the seat belt buckle.
3. Guide the seat belt back into its roll-up
mechanism.
Seat belt reminder
General information
Make sure that the seat belts are positioned
correctly.
The seat belt reminder becomes active in the
following situations:
▷ When the seat belt on the driver's side or
on the passenger's side is not fastened.
▷ When the seat belt is unfastened while driv-
ing.
▷ When objects are lying on a seat.
Display in the instrument cluster
The indicator light in the instrument cluster illu-
minates after turning on the drive-ready state
when the seat belt reminder is active.
98
Seats, mirrors and steering wheel
Online Edition for Part no. 01405A5E788 - VI/22
A Check Control message is displayed where
applicable. Check whether the seat belt has
been fastened correctly.
Icon Meaning
Seat belt on the driver's seat is
not buckled.
Seat belt on the passenger
seat or another seat in the ve-
hicle is not buckled.
Seat belt is buckled on the cor-
responding seat.
Seat belt is not buckled on the
corresponding seat.
Rear seat reminder system
Principle
At the end of a trip, the system informs the
driver of the possible presence of occupants on
the rear seats.
General information
If a door with access to the rear row seating
is operated within 30 minutes before starting
off, a message appears on the control display
when the trip is completed and a signal tone
sounds.
If the trip is continued within 30 minutes, the
message is displayed again after the trip has
been completed.
Activate/deactivate the function
1. "MENU"
2. "System settings"
3. Rear seat reminder system
4. Select the desired setting.