Ir Sensor Board - HP OMEN 16-k0 Series Maintenance And Service Manual

3. Remove the board (3).
To install the USB board, reverse this procedure.

IR sensor board

To remove the IR sensor board, use this procedure and illustration. Before removing the board, you can
remove the system board, heat sink, and fans as an assembly so you do not have to disturb the thermal
material.
Table 6-12 IR sensor board description and part number
Description
IR sensor board
IR sensor board cable
Before removing the IR sensor board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the system board, heat sink, and fan assembly (see
page 48).
Remove the IR sensor board:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the board to the top of the computer.
Preparation for disassembly on page
Bottom cover on page
Battery on page 37).
36).
System board, heat sink, fan combination on
Spare part number
N14065-001
N14066-001
36).
IR sensor board 53