3.
Remove the battery (see
4.
Remove the solid-state drive (see
5.
Remove the memory modules (see
6.
Remove the WLAN module (see
7.
Remove the heat sink (see
8.
Remove the fans (see
Remove the system board:
1.
Disconnect the following cables from the system board:
Display cable (1)
●
Sensor board cable (ZIF) (2)
●
RJ-45 (network) board cable from the RJ-45 board (ZIF) (3)
●
Wireless antenna cables from the WLAN module (4)
●
Left speaker cable (5)
●
Card reader cable (ZIF) (6)
●
Touchpad cable (ZIF) (7)
●
Keyboard cable (ZIF) (8)
●
Keyboard RGB (ZIF) (9) (select products only)
●
Backlight cable (ZIF) (10)
●
Right speaker cable (11)
●
USB board cable from the USB board (12)
●
2.
Remove the rear ports bracket my removing the three Phillips M2.0 × 5.0 screws (1), and then removing
the bracket (2).
64
Chapter 6 Removal and replacement procedures for authorized service provider parts
Battery on page
37).
Solid-state drive on page
Memory modules on page
WLAN module on page
Heat sink assembly on page
Fans on page
47).
32).
33).
39).
46).