Table of Contents
Advertisement
IR board
To remove the IR board, use this procedure and illustration.
Table 5-12
IR board description and part number
Description
IR board
IR board cable
Before removing the IR board, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the system board (see
Remove the IR board:
1.
Remove the Phillips M2.0 × 3.0 screw (1) from the board .
2.
Remove the board (2) from the computer.
3.
Turn the board upside down, and then disconnect the cable from the ZIF connector (3) on the board.
The cable connector is covered with protective tape. The cable is secured with double-sided tape.
To install the IR board, reverse this procedure.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Preparation for disassembly on page
Bottom cover on page
Battery on page
31).
System board on page
29).
44).
Spare part number
N87230-001
N87220-001
29).
IR board
47
Advertisement
Table of Contents
