Table of Contents
Advertisement
Remove the card reader:
1.
Disconnect the cable from the ZIF connector on the system board (1).
2.
Remove the two Phillips M2.0 × 2.5 screws (2) that secure the card reader to the computer.
3.
Remove the card reader from the computer (3).
To install the card reader, reverse this procedure.
Per key lighting board
To remove the lighting board, use this procedure and illustration.
Table 6-6
Lighting board description and part number
Description
Lighting board
Lighting board LED cable
Lighting board keyboard cable
Before removing the lighting board, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the lighting board:
1.
Remove the two Phillips M2.0 × 2.5 screws (1) that secure the board to the computer.
42
Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
37).
36).
Spare part number
available with the top
cover with keyboard
spare part
N14074-001
N14073-001
36).
Advertisement
Table of Contents
