Sensor Board - HP ZBook Power G10 Maintenance And Service Manual

4. Remove the fingerprint reader board (4)
To install the fingerprint reader board, reverse this procedure.

Sensor board

To remove the sensor board cable, use this procedure and illustration.
Table 5-12 Sensor board cable description and part number
Description
Sensor board
Sensor board cable (included in the Cable Kit)
Before removing the sensor board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the sensor board:
1. Remove the two Phillips M2.5 × 5.0 screws from the left hinge (1), and then rotate the hinge up and
off the sensor board (2).
2. Disconnect the cable from the ZIF connector (3) on the sensor board.
3. Remove the Phillips M2.0 × 5.0 screw (4) that secures the sensor board to the computer.
Preparation for disassembly on page
Bottom cover on page 37).
Spare part number
N56100-001
N56092-001
Battery on page 39).
37).
Sensor board 53