Siemens SIMATIC RF200 System Manual page 95

Error code Error description
(hex)
5100 General problem
with the power
supply
6000 Firmware error
6320 Parameter
assignment error
8C00 Reset Device
The device status has the same meaning as the RFID error code.
1)
Note
You can display these event messages using S7-PCT or read them out using the
"IOL_CALL" function block. You can only reset event messages using S7 PCT or the
"IOL_CALL" function.
The event messages cannot be reset by "antenna off" or "move transponder out of field" as
is possible with the RFID errors (compare section "Diagnostics (Page 81)").
SIMATIC RF200 IO-Link
System Manual, 03/2012, C79000-G8976-C276-01
Device status )
1
RFID error code (hex) 11
RFID error code (hex) 14
RFID error code (hex) 15
RFID error code (hex) 14
Event type Causes of errors
Error Hardware fault:
coming/ Under/overvoltage
going Check the power supply.
Error The firmware has detected an internal error
coming/ (system).
going For example illogical status or watchdog etc.
Error Parameter assignment error:
coming/ Bad parameter
going
Error Serious system error, watchdog:
coming/
Cycle power
going
Appendix
A.1 IO-Link error codes
95