Commissioning and parameter assignment
5.2 Parameter assignment of the IO-Link system
Figure 5-6
Note
Calling the PCT with STEP 7 V5.4 or older installed
If PCT was not installed along with the STEP 7 installation (up to V5.4), you will need to
install PCT extra. In this case, you can call up PCT directly using the master. Right click on
the master and then on "Configure IO-Link" in the shortcut menu.
46
Calling the PCT from HW Config using the master
SIMATIC RF200 IO-Link
System Manual, 03/2012, C79000-G8976-C276-01