Dyson DC18 Service Manual page 37

155
To refit, locate the gimblelock pin into the
hole in the front of the undercarriage.
156
Refit the spring onto the cruciform on the
gimble lock cover. Locate the gimble lock cover
under the retainer on the undercarriage. Lower
the gimble lock cover onto the screw boss. Refit
the screw.
157
If the pedal needs replacing, undo the
screws on either side of the undercarriage.
Issued 10/06
158
Prise the pedal lugs out the side of the
undercarriage. Remove the pedal.
159
To fit a new pedal, press the pedal plunger
down. Slide the pedal over the top of the pedal
plunger and into the holes in the side of the
undercarriage. Refit the plastic washers and screws.
160
To replace the pedal plunger or spring,
position the undercarriage assembly into the
vacuum mode and push the pedal plunger
through the base of the undercarriage.
service manual
34