Dyson DC18 Service Manual page 16

service manual
Yoke assembly - fitting
37
Feed the coiled cable assembly through the
opening in the front of the yoke assembly.
38
Position the yoke assembly onto the front of
the undercarriage assembly.
39
Position the barrel wheel assembly between
the undercarriage assembly. Slide the barrel
wheel axle into the yoke assembly and barrel
wheel assembly.
13
40
Refit the e-clip onto the end of the barrel
wheel axle.
41
Position the coiled cable assembly grommet
onto the locator on the swivel. Lower the cable
connector into the swivel.
42
Dress the coiled cable wires neatly in the
swivel. Refit the swivel cover ensuring no wires
are trapped/visible. Refit the short screw.
Issued 10/06