87
Locate the cyclone release catch spring
between the cyclone release catch and duct
assembly.
88
Refit the exhaust seal onto the duct assembly.
89
Refit the entry seal onto the duct assembly.
A A f f t t e e r r a a s s s s e e m m b b l l i i n n g g t t h h e e p p a a r r t t s s o o n n t t o o t t h h e e d d u u c c t t
a a s s s s e e m m b b l l y y , , t t h h e e f f o o l l l l o o w w i i n n g g p p a a r r t t s s s s h h o o u u l l d d b b e e
f f i i t t t t e e d d a a s s p p r r e e v v i i o o u u s s l l y y s s h h o o w w n n : :
Powercord and switch cover (pages 18 - 19)
Undercarriage assembly (page 16)
Yoke assembly (pages 13 - 14)
Motor assembly (pages 9 - 11)
Issued 10/06
Sub assemblies - cleaner head -
dismantle
90
Undo the endcap fasteners from either side
of the brush housing using a large flat bladed
screwdriver or coin.
91
Twist the endcap assemblies off either side
of the brush housing.
92
Remove both halves of the brushbar assembly
from the brushbar motor assembly.
service manual
22