Dyson DC18 Service Manual page 13

Ensure the wire
is free from this
screw boss
20
Lower the motor into the inner bucket.
Ensure the motor is orientated as shown (the
motor mount should align with the line on the
duct). I I m m p p o o r r t t a a n n t t : : ensure all wires are free
from screw bosses.
21
Refit the motor retainer ensuring the detail
on the cover 'keys' onto the motor mount. It
may be necessary to adjust the orientation of the
motor to align the motor retainer with the screw
bosses. Refit the 3 screws.
22
Refit the motor retainer seal and post motor
seal onto the motor retainer ring.
Issued 10/06
23
Align the motor retainer ring over the four
screw bosses. Push firmly onto the motor
retainer screw bosses. Refit the four screws.
1 1
2 2
24
Align the post filter cover onto the motor
retainer ring (1). Push and twist into position (2).
service manual
10