Dyson DC18 Service Manual page 17

43
Refit the internal hose assembly into the
front of the yoke assembly. Locate the internal
hose firmly onto the undercarriage assembly.
44
Press the outer wheel hubs firmly onto the
retainers on either side of the yoke assembly.
45
Refit the cleanerhead onto the front of the
product.
Issued 10/06
Undercarriage assembly - removal
B B e e f f o o r r e e c c o o n n t t i i n n u u i i n n g g t t h h e e f f o o l l l l o o w w i i n n g g p p a a r r t t s s
s s h h o o u u l l d d b b e e r r e e m m o o v v e e d d a a s s p p r r e e v v i i o o u u s s l l y y s s h h o o w w n n : :
Yoke assembly (pages 11 to 12).
46
Press the hose release catch on the bottom of
the hose assembly. Remove the hose assembly.
47
Carefully separate the two halves of the
connector housing assembly using a thin flat
bladed screwdriver.
48
Undo the Torx T-8 screw on the side of the
undercarriage assembly.
service manual
14