Dyson DC18 Service Manual page 22

service manual
70
Assemble the brushbar reset arm and
spring into the brushbar actuator as shown.
71
Lower the brushbar actuator into the switch
cover.
72
Lower the ON/OFF button and spring into
the switch cover.
19
73
Press both switches into the ON position.
Lower the switch cover onto the duct assembly
with both buttons protruding from the top. Clip
the base of the switch cover only onto the duct.
74
I I m m p p o o r r t t a a n n t t : : before locating the top of the
switch cover onto the duct assembly ensure the
brushbar reset arm locates into the detail on the
front of the duct assembly. Failure to do so may
result in the inability to turn the brushbar off
using the switch. Once the arm is located press
the switch cover onto the duct assembly. Refit
the four screws in the rear of the duct.
on
7am -10pm 7 days a
www.dyson.c
Issued 10/06