Dyson DC18 Service Manual page 19

Undercarriage assembly - fitting
54
Ensure the duct seal is located onto the
base of the duct assembly.
55
(1)Feed the coiled cable assembly through
the hole in the front of the undercarriage
assembly. (2)Feed the upright micro switch
carefully through the top of the undercarriage
assembly and then through the hole in the side.
56
Align the detail on the rear of the
undercarriage assembly with the channel on the
duct. Slide into place ensuring the pipe on the
side of the undercarriage assembly locates into
the duct seal. Refit the two screws on the rear
of the duct and the four cheesehead screws on
the front of the undercarriage assembly.
Issued 10/06
1
2
57
Carefully locate the upright micro switch onto
the two retaining pips in the undercarriage
assembly. Dress the wires neatly into the channel.
Refit the micro switch cover and T-8 screw.
58
Position the coiled cable assembly wires into
the base of the female connector assembly.
Clip the top of the female connector assembly
onto the base.
A A f f t t e e r r f f i i t t t t i i n n g g t t h h e e u u n n d d e e r r c c a a r r r r i i a a g g e e a a s s s s e e m m b b l l y y
t t h h e e f f o o l l l l o o w w i i n n g g p p a a r r t t s s s s h h o o u u l l d d b b e e f f i i t t t t e e d d a a s s
p p r r e e v v i i o o u u s s l l y y s s h h o o w w n n : :
Yoke assembly (pages 13 to 14).
service manual
16