Dyson DC18 Service Manual page 14

service manual
25
Align the arrow on the HEPA filter
assembly/standard post filter cage with the
arrow on the post filter cover.
26
Refit the lower cable winder onto the rear of
the duct assembly. Refit the 2 cheesehead screws.
27
Clip the end of the hose into the wand
handle. Lower the wand handle onto the duct
assembly. Slide the tube into the wand assembly.
Refit the cyclone and bin assembly onto the front
of the duct assembly.
11
Yoke assembly - removal
28
Press the two release catches and remove
the cleanerhead assembly from the front of the
product.
29
Undo the short screw on the underside of
the swivel.
30
Carefully prise off the swivel cover. Detach
the female connector assembly and coiled cable
grommet from the swivel.
Issued 10/06