Dyson DC18 Service Manual page 34

service manual
138
The crevice tool clip can be pushed out of
the side of the duct with a screwdriver and a new
one pressed back in place.
139
Firmly prise the wand release catch and
spring out of the top of the duct if necessary
using a large flat bladed screwdriver.
140
Firmly press the wand release catch and
spring under the ribs on the rear of the duct.
Push the catch into position until it clips into
place.
31
Sub-assemblies - internal cable
looms assembly
141
The micro switch loom assembly, cleaner
head coiled cable loom assembly or internal
cable assembly can be replaced. Carefully
release the relevant wires from the channel and
detach.
142
Prise the grommet out of the inner bucket
with a thin screwdriver.
143
When fitting any one of the assemblies,
ensure all wires are neatly dressed into the base
of the inner bucket and the grommets are
correctly located under the retaining ribs.
Issued 10/06