僅 Side Repeater Lamp (Led Type) Bulb Replacement - Kia PICANTO 2023 Manual

Maintenance
6. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
7. Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly. Push the
socket into the assembly and turn the
socket clockwise.
8. Connect the front fog lamp connector.
9. Install the engine under cover assem-
bly to the body of the vehicle.
Side repeater lamp (Bulb type)
bulb replacement
OJA070103
1. Remove the lamp assembly from the
vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connec-
tor.
3. Separate the socket and the lens parts
by turning the socket counterclock-
wise until the tabs on the socket align
with the slots on the lens part.
4. Remove the bulb by pulling it straight
out.
5. Insert a new bulb in the socket.
6. Reassemble the socket and the lens
part.
7. Connect the bulb electrical connector.
8 94
8. Reinstall the lamp assembly to the
body of the vehicle.
Side repeater lamp (LED type)
bulb replacement
OJA070141
If the side repeater lamp (LED type) (1)
does not operate, have your vehicle
checked by a professional workshop. Kia
recommends to visit an authorised Kia
dealer/service partner.The LED lamp
cannot be replaced as a single compo-
nent because it is an integrated unit. The
LED lamp has to be replaced with the
unit.A skilled technician should check or
repair the side repeater lamp (LED type),
for it may damage related parts of the
vehicle.
Rear turn signal lamp (Bulb type)
bulb replacement (Rear combina-
tion lamp Type A, B, C)
1. Open the tailgate.
2. Loosen the light assembly retaining
screws with a cross-tip screwdriver.
3. Remove the rear combination lamp
assembly from the body of the vehi-
cle.
4. Disconnect the rear combination lamp
connector.
Light bulbs