Intermec PB50 User Manual page 28

Chapter 2 — Configuring the PB50
20
Using Extended Test Mode
Use Extended Test mode to run additional diagnostic tests,
including printing specific test labels, entering Dump mode, and
resetting to factory defaults.
TEST LABELS
CHESS
Sample Extended Test Mode Scree
To enter Extended Test mode
1 Make sure that the printer is loaded with media.
2 Press the media cover release button to open the media cover.
3 Press the Standby button to turn the printer off.
4 Press Feed and Standby buttons at the same time until
CLOSE PRINTER DOOR appears on the screen.
5 Close the media cover. You are now in Extended Test mode.
• Press to cycle through the options.
• Press to select a test option.
• Press to exit Extended Test mode.
Options in Extended Test Mode
Function
Select Media
Test Labels
Description
This option is almost the same as the process
in Test mode, except that the printer performs
a slow test feed in Extended Test mode. The
slow test feed enables the printer to perform a
slow sensor calibration which can help resolve
gap or mark detection problems.
This option allows you to print test labels one
at a time. Press to print the next label.
PB50 Mobile Label Printer User's Guide