Configuring Wireless Printing Using Ipl - Intermec PB50 User Manual

PB50 Mobile Label Printer User's Guide

Configuring Wireless Printing Using IPL

Use the following procedures to configure your PB50 with IPL
for wireless printing.
To configure the printer to use WEP authentication
1 Send the following commands to login as an admin and set
the SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,xxxxx<ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
Note: The default password for logging in as an admin is
"pass." If you have changed the password, you will need to use
your password instead of "pass."
2 Send the following commands to configure the WEP keys.
The following example sets WEP key 1 to 1234 and enables
WEP key 1.
<STX><SI>ws,WEP1, 0x0001020304<ETX>
<STX><SI>ws,.WEP_KEY,1<ETX>
3 Send the following command to activate the settings.
<STX><SI>ws,ACTIVE,1<ETX>
To configure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an admin and set
the SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,xxxxx<ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following commands to turn on WPA or
WPA2 authentication. Send the WPA-PSK or WPA2-PSK
command to set a pre-shared key:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, xxxxxxxxxx<ETX>
where xxxxxxxxxx is a value between 8 and 64 characters.
3 Send the following command to activate the settings:
<STX><SI>ws,ACTIVE,1<ETX>
Chapter 2 — Configuring the PB50
29