Intermec PB50 User Manual page 38

Chapter 2 — Configuring the PB50
30
To configure the PB50 to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an admin and set
the SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID,xxxxx<ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
Note: The default password for logging in as an admin is
"pass." If you have changed the password, you will need to use
your password instead of "pass."
2 Send one of the following commands to enable WPA-802.1x
or WPA2-802.1x authentication. You should also send the
WPA_PSK command that does not contain a value:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, <ETX>
3 Send these commands to configure the EAP_TYPE:
<STX><SI>ws,EAP_TYPE,xxxx<ETX>
where xxxx can be OFF, LEAP, PEAP, or TTLS.
<STX><SI>ws,.EAP_USER,xxxx<ETX>
<STX><SI>ws,.EAP_PASS,xxxx<ETX>
where xxxx is the unique username and the unique password
for this protocol.
4 If you are using TTLS, you may need to send this command
to set the TTLS outer name:
<STX><SI>ws,TTLS_USER,
where xxxx is the outer name.
5 If you are using certificates for validation, here are some
commands you may need to use.
• Send the following commands to set a certificate and
enable validation:
<STX><SI>ws,CA_CERT,c:/testCA.pfx@export<ETX>
<STX><SI>ws,VALIDATE,ON<ETX>
where c:/testCA.pfx is the location and name of the
certificate and export is the passphrase.
xxxx <ETX>
PB50 Mobile Label Printer User's Guide