Setting Up Usb Communications - Intermec PB50 User Manual

Setting Up USB Communications

PB50 Mobile Label Printer User's Guide
setup "8021x",".EAP_USER","xxxx"
setup "8021x","EAP_PASS","xxxx"
where xxxx is the unique username and the unique password
for this protocol.
4 If you are using TTLS, you may need to send this command
to set the TTLS outer name:
setup "8021x","TTLS_USER","xxxx"
where xxxx is the outer name.
5 If you are using certificates for validation, here are some
commands you may need to use.
• Send the following commands to set a certificate and
enable validation:
setup "8021x","CA_CERT","c:/test.pfx@export"
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certificate
and export is the passphrase.
• Send the following commands to set a common name for
server 1 and server 2:
setup "8021x",".SERVER_CN1","xxxxxxxxxx"
setup "8021x",".SERVER_CN2","xxxxxxxxxx"
where xxxxxxxxxx can be a value from 0 to 64 characters.
• Send the following command to make sure your values
match those used by the access point:
setup write "8021x","uart1:"
• You may need to send the following command several
times for the wireless station to connect:
setup "wlan","ACTIVE","1"<ETX>
To set up USB communications with your PC, you will need:
• USB cable
• Intermec InterDriver® software
You can download the InterDriver software from the Intermec
web site at www.intermec.com.
Chapter 2 — Configuring the PB50
33