Cold Booting The Pb50; Cleaning The Printer - Intermec PB50 User Manual

Chapter 3 — Troubleshooting and Maintaining the PB50

Cold Booting the PB50

Cleaning the Printer

44
3 Press to enter the Test/Service menu.
4 Press until you reach Data Dump and then press
5 Press to select Yes and then press
6 Cold boot the printer to exit Dump mode. For help, see the
next procedure, "Cold Booting the PB50."
You rarely need to cold boot the PB50 printer, unless you are
upgrading the firmware. If your printer occasionally locks up,
you will want to cold boot it. A cold boot reinitializes the 802.11
radio and clears the working memory.
Note: The Setup menu is not affected by a cold boot. Your
printer retains all of your configuration settings after the printer
powers back up.
To reset the PB50
1 Disconnect the PB50 from power if externally powered.
2 Remove the battery from the PB50 for at least one second.
3 Insert the battery back into the PB50.
4 Reconnect external power if your PB50 is externally powered.
To properly maintain your PB50, you should clean it at the
recommended intervals.
To avoid possible personal injury or damage to the printer,
never insert any pointed or sharp objects into the printer.
Use only the cleaning agents specified in this section. Intermec
is not responsible for damage caused by any other cleaning
materials used on this printer. Clean the printer with a cotton
swab saturated with alcohol.
.
PB50 Mobile Label Printer User's Guide
.