Feedadjust; Startadjust; Stopadjust - Intermec EasyCoder F2 Installation And Operation Manual

Setup Parameters, cont'd.

Feedadjust

• Startadjust

• Stopadjust

Recommended Feed Adjustments
The following settings allow
printing from the top of the label.
Minor deviations from the
recommended values may be
required due to various com-
binations of media types, roll
size, type of media supply device,
and individual differences
between printers.
Tear-Off:
Start adjust: -100 (-12.5 mm)
Stop adjust: 0
Peel-Off:
Start adjust: -56
Stop adjust: -44
Intermec EasyCoder F2 – Installation & Operation Ed. 1
The Feedadjust part of the Setup Mode is used to feed out or pull
back the paper before and/or after the actual printing. These set-
tings are global and will be effected regardless of which program is
run.
Note that the firmware uses the front edges of labels w. gaps, the
ends of detection slots and the forward edges of black marks for
detection, all seen in relation to the paper feed direction.
Start Adjust
The Start Adjust value is given as a positive or negative number of
dots (1 dot = 0.125 mm = 4.9 mils). Default value is 0, which places
the origin a certain distance back from the forward edge of the copy.
• A positive start adjustment means that the specified length of
paper web will be fed out before the printing starts, i.e. the origin
is moved further back from the forward edge of the copy.
• A negative start adjustment means that the specified length of
paper web will be pulled back before the printing starts, i.e. the
origin is moved towards the forward edge of the copy.
Stop Adjust
The Stop Adjust value is given as a positive or negative number of
(0 mm)
dots (1 dot = 0.125 mm = 4.9 mils). Default value is 0, which stops
the paper feed in a position suitable for tear off operation.
(-7.0 mm)
• A positive stop adjustment means that the normal paper feed after
(-5.5 mm)
the printing is completed will be increased by the specified value.
• A negative stop adjustment means that the normal paper feed
after the printing is completed will be decreased by the specified
value.
Chapter 6 Setting Up the Printer
47