Usb Interface - Intermec EasyCoder F2 Installation And Operation Manual

USB Interface

USB = Universal Serial Bus
Intermec EasyCoder F2 – Installation & Operation Ed. 1
The EasyCoder F2 has – as standard – one USB communication
port. To use the USB interface for printing from a PC, you need a
special USB printer driver installed in your PC.
Using an USB Class A - B cable, connect the Class A end to your
PC or hub and the Class B end to your EasyCoder F2 printer.
There is no communication setup for the USB interface.
USB
Connect to USB receptacle on the printer's rear plate.
Note:
The USB interface is presently not supported by the Intermec Fin-
gerprint firmware (v. 7.2).
Appendix 3
USB Class A connector.
Connect to PC or hub.
USB Class B connector.
Communication Cables
95