Print Speed; Lts (Label-Taken Sensor) - Intermec EasyCoder F2 Installation And Operation Manual

Setup Parameters, cont'd.
Print Defines, cont'd.
Intermec EasyCoder F2 – Installation & Operation Ed. 1

Print Speed

The print speed is variable between 100 and 200 mm/sec. Gener-
ally, the lower the speed, the better the printout quality. This is espe-
cially the case when printing bar codes with the bars running across
the paper web ("ladder style"), when printing on demanding face
materials, and when printing at low ambient temperatures. Refer to
the tables under "Media" earlier in this chapter for maximum print
speed values. The default setting is 100 mm/sec.

LTS (Label-Taken Sensor)

The sensitivity of the LTS may need to be adjusted according to
ambient light conditions and reflective characteristics of the back
side of the paper. The LTS setup options are only displayed if an
optional label-taken sensor is installed in the printer.
• LTS Adjust:
Press <Enter>. A label is feed out. Remove the label and press
<Enter> again. A menu shows the sensitivity automatically
selected by the firmware and the range, in which the LTS will
work. Press <Enter> again and you will proceed to the LTS Test
menu.
• LTS Test:
Press <Enter>. A label is fed out. Remove the label and a new
label should be fed out automatically. Repeat until you are sure
the LTS works properly. Then press <Enter> to stop and exit.
• LTS Value:
Press <Enter>. You can enter a new value in the range indicated
in the LTS Adjust menu (see above). Min/max values are in the
range 0–10.
Chapter 6 Setting Up the Printer
54