Net Communication; New Line; Feedadjust; Startadjust - Intermec easycoder f2 Installation & Operation Manual

Setup Parameters, cont'd.

Net Communication

• New Line

Feedadjust

• Startadjust

• Stopadjust

Recommended Feed
Adjustments
The following settings allow
printing from the top of the
label. Minor deviations from
the recommended values may
be required due to various com-
binations of media types, roll
size, type of media supply device,
and individual differences bet-
ween printers.
Tear-Off:
Start adjust: -100 (-12.5 mm)
Stop adjust: 0
Peel-Off:
Start adjust: -56
Stop adjust: -44
Intermec EasyCoder F2 – Installation & Operation Ed. 2
New Line
Only shown if an optional EasyLAN 100i interface board is fi tted and
used to select the character(s) transmitted from the printer, to specify
the switching to a new line. There are three options:
• CR/LF
• LF
• CR
The Feedadjust part of the Setup Mode is used to feed out or
pull back the paper before and/or after the actual printing. These
settings are global and will be effected regardless of which program
is run.
Note that the fi rmware uses the front edges of labels w. gaps, the ends
of detection slots and the forward edges of black marks for detection,
all seen in relation to the paper feed direction.
Start Adjust
The Start Adjust value is given as a positive or negative number
of dots (1 dot = 0.125 mm = 4.9 mils). Default value is 0, which
places the origin a certain distance back from the forward edge
of the copy.
• A positive start adjustment means that the specifi ed length of
paper web will be fed out before the printing starts, i.e. the origin is
moved further back from the forward edge of the copy.
• A negative start adjustment means that the specifi ed length of
paper web will be pulled back before the printing starts, i.e. the
origin is moved towards the forward edge of the copy.
Stop Adjust
The Stop Adjust value is given as a positive or negative number of
(0 mm)
dots (1 dot = 0.125 mm = 4.9 mils). Default value is 0, which stops the
paper feed in a position suitable for tear off operation.
• A positive stop adjustment means that the normal paper
(-7.0 mm)
feed after the printing is completed will be increased by
(-5.5 mm)
the specifi ed value.
• A negative stop adjustment means that the normal paper
feed after the printing is completed will be decreased by
the specifi ed value.
Chapter 6 Setting Up the Printer
ASCII 13 dec. + ASCII 10 dec.
ASCII 10 dec.
ASCII 13 dec.
(default)
45