Installation Unpacking - Intermec EasyCoder 601 XP Installation And Operation Manual

Installation
Unpacking
Intermec EasyCoder 601 XP – Installation & Operation Ed. 3
Before you install the printer, examine the delivery for possible dam-
age or missing parts:
• Open the box and lift the printer out.
• Check that the printer has not been visibly damaged during
transportation. Keep the packing materials in case you need to
move or reship the printer.
• The label on the printer's rear plate gives the voltage, the part
number and the serial number.
• Check that any options you ordered are included.
• Check that all the accessories are included in the delivery. In
addition to any separately ordered options, the box should contain:
- Intermec EasyCoder 601 XP printer
- Adapters for 3" paper roll core (2 pcs)
- Paper guide for label slack absorber
- Power cord
- Quality check card
- Cleaning card
- Approx. 2 metres of labels
- Starter pack of thermal transfer ribbon
- User's Guide (multilingual)
- Installation & Operation manual
- Setup bar codes sheet for EasySet wand
- Floppy disk with MS Windows printer drivers
• Check that the power cord are appropriate for the local standard.
The printer works within 100 – 240 V AC, 50 – 60 Hz.
European type
230V mains plug
If the printer has been damaged in any way during transportation,
complain to the carrier immediately.
If the delivery is incorrect or any parts are missing, report it imme-
diately to the distributor.
US/Canadian type
115V mains plug
Chapter 3
GB type
230V mains plug
16