Table of Contents
Advertisement
11. Reset Setup to Default
11.1 Resetting the
Setup
Intermec ColorCoder V4 – Installation & Operation Ed. 1
Use the following procedure to return printer settings stored in the
printer's memory to their default values.
Notice:
Refer to chapter 11.2 for a list of default values.
. If "READY" is displayed on the display panel, press the <On
1
line> key.
OFF LINE
. Press the <Menu> key.
2
PAPER TYPE
. Press the <Cursor right> key four (4) times until this menu is
3
displayed:
MAINTENANCE
. Press the <Enter> key.
4
TEST PRINT
. Press the <Cursor left> key once.
5
NVRAM
. Press the <Enter> key.
6
NVRAM RESET
. Press the <Enter> key. All settings are reset to their respective
7
default values as listed in chapter 11.2. Press the <Menu> key
repeatedly to return to the "OFF LINE" menu.
Chapter 11
105
Advertisement
Table of Contents
