Default Setup - Intermec easycoder f2 Installation & Operation Manual

Default Setup

Intermec EasyCoder F2 – Installation & Operation Ed. 2
The printer is by default set up according to the list below:
Ser-Com "uart1:"
Baudrate:
Character length:
Parity:
Stop bits:
RTS/CTS:
ENQ/ACK:
XON/XOFF, data to host:
XON/XOFF, data from host:
New line:
Receive buffer:
Transmit buffer:
Feedadjust:
Startadjust:
Stopadjust:
Media:
X-start:
Width:
Length:
Media Type:
Label Constant:
Label Factor:
Contrast:
Print Defi nes:
Print speed:
The printer's current setup values can be read from the display by
browsing through the Setup Mode, or from the host by browsing
through the Terminal Setup of Intermec Shell.
You can list the printer's current setup values by printing test label
#5 in the Setup Mode or using Intermec Shell.
The current setup values can be returned to the host by means of a
SETUP WRITE "uart1:" statement (see Intermec Fingerprint
7.xx Reference Manual).
Chapter 6 Setting Up the Printer
9600 bps
8 bits
None
1 bit
Disable
Disable
Disable
Disable
CR/LF
300 bytes
300 bytes
0
0
24
424
1200
Label (w Gaps)
85
40
±0%
100 mm/sec.
41