Default Setup - Intermec EasyCoder PM4i User Manual

Default Setup

The printer's default setup is listed below (assuming no options installed):
Ser-Com "uart1:"
Baud rate
Character length
Parity
Stop bits
RTS/CTS
ENQ/ACK
XON/XOFF, data to host
XON/XOFF, data from host
New line
Receive buffer
Transmit buffer
Feedadjust:
Startadjust
Stopadjust
Media:
X-start (8 dots/mm = 203.2 dpi)
X-start (11.81 dots/mm = 300 dpi)
Width (8 dots/mm = 203.2 dpi)
Width (11.81 dots/mm = 300 dpi)
Length (8 dots/mm = 203.2 dpi)
Length (11.81 dots/mm = 300 dpi)
Media type
Paper type
Ribbon constant
Ribbon factor
Label offset
Low diameter (ribbon)
Contrast
Print Defines:
Print speed
Intermec EasyCoder PM4i—User's Guide (Fingerprint version)
Chapter —Setting Up the Printer
9600 bps
8 bits
None
1 bit
Disable
Disable
Disable
Disable
CR/LF
1024 bytes
1024 bytes
0 dots
0 dots
24 dots
36 dots
832 dots
1248 dots
1200 dots
1800 dots
Label (w Gaps)
Thermal transfer
90
25
0
0 dots
±0%
100 mm/sec.
4