HP HPE 3PAR StoreServ 8000 Installation Manual page 87

Table 28 Service processor installation checklist
3PAR StoreServ Storage serial number
The 3PAR StoreServ Storage system serial number can be obtained from the
following locations:
At the rear of the system, next to the power switch for the controller node
enclosure PCM
In the product documentation provided with your system
SP Host Name
NOTE: During the SP setup process, the 3PAR StoreServ Storage must be
powered on, connected to the same network subnet as the SP, and non-initialized
to allow the SP to verify the 3PAR StoreServ Storage serial number. Legacy 3PAR
StoreServ Storage systems used 7-digit serial numbers for configuration. The
3PAR StoreServ 8000 Storage no longer has a 7-digit serial number, but uses
instead a 10-character serial number for configuration.
This requires up-to-date versions of HPE 3PAR SP and VSP software and of HPE
3PAR SmartStart.
Static IP address (IPv4 only)
Subnet mask
Gateway IP address
DNS settings:
Domain name
DNS servers
Maximum supported speed and duplex setting:
Autonegotiate (During moment of birth (MOB), use the AUTO setting unless
your network requires a different speed configuration. Press Enter to accept
the default network speed, or enter the specific network speed and then press
Enter.)
Custom duplex (half or full) and Custom speed (10, 100, or 1000 MB/s)
Proxy server settings for Remote Support (if applicable):
Protocol
Address and port
Authentication information (optional)
System Support Information:
Installation site information
Customer information
Date and time:
HPE 3PAR Service Processor
CAUTION: Do not enable
DNS settings while you are
initializing the system software;
the system will fail. See
StoreServ Storage Detection
Issues" (page 130)
You may need DNS settings
later if you want to verify remote
support connectivity. To
configure DNS settings manually
after you have completed
software initialization, see
"Service Processor Initialization"
(page 90)
System Software Installation Checklist
"3PAR
87