System Wizard Step 1—Welcome
The Welcome page shows the information that is required to complete the wizard and set up
the SP.
1.
Obtain the following information:
The 10-digit system serial number
NOTE:
install and configure your 3PAR StoreServ 8000 Storage, use the new 10-digit serial
number.
This requires up-to-date versions of 3PAR SP and VSP software and of 3PAR SmartStart.
System name
System networking information:
◦
◦
Time zone information:
◦
◦
2.
Click Next to proceed to the next wizard step.
Legacy 3PAR StoreServ Storage systems had 7-digit serial numbers. To
IP address (IPv4 only)
Subnet mask and gateway
Date and time or Network Time Protocol (NTP) server address if using automatic
date/time configuration
Time zone region
HPE 3PAR Storage System Setup Wizard 109