Cabling Power Distribution Units
PDUs can be mounted horizontally below the enclosures at the bottom of the rack. Each PDU
AC cord connects to the appropriate outlet based on the type of cord and power requirements
to supply power to the system.
To access the vertically mounted PDUs or servicing area, the PDUs can be lowered out of the
rack.
1.
Remove the two top mounting screws.
2.
Pull down on the PDU to lower.
NOTE:
down the PDU.
3.
Ensure that the PDUs are in a fully lowered position before accessing.
Figure 81 Disengage PDU Pivot brackets
Cabling Power Strips
Power strips can be located on the side of the rack to supply power to the PCMs. Power strips
are connected to PDUs. Do not exceed the capabilities of power strips and PDUs.
Continue on
and initializing the SP and system software.
82
System Cabling
If necessary, loosen the two bottom screws to unhinge the bracket before pulling
to"System Setup Verification" (page
83), before powering on the system