Uninstalling The System - HP HPE 3PAR StoreServ 8000 Installation Manual

◦
Number of drive cages
◦
Number of drive magazines — showcage –d
◦
Number and sizes of drives on the magazines — showpd
Physical condition of system hardware and cabinet (note presence of scratches, dents,
missing screws, broken bezels, damaged ports, and other visible anomalies)
Destination address or addresses and list of the equipment going to each address
NOTE: In this and other chapters, the command-line examples use bold type to indicate user
input and angle bracket (< >) to denote variables. Examples may not match the exact output any
particular system.

Uninstalling the System

NOTE: If you are planning to reinstall using the existing license, record the license before
completing this uninstall procedure. Use the following commands to record the existing license:
showlicense and showlicense -raw.
This section provides instructions for uninstalling a system.
1. Connect the laptop to the highest numbered controller node with a serial cable.
2. Using a terminal emulator program, such as Putty, set your maintenance laptop console to
the following settings.
Baud rate
Data bits
Parity
Stop bits
Flow control
3. Log into the node as the console user.
3PAR(TM) OS <version> <sernum>-<nodeID> ttyS0
(none) login: console
Password: <password>
NOTE:
4. From the console menu, enter 8 to select Perform a deinstallation.
3PAR Console Menu 1400293-1 3.x.x.xxx
1. Out Of The Box Procedure
2. Re-enter network configuration
3. Update the CBIOS
4. Enable or disable CLI error injections
5. Perform a Node-to-Node rescue
6. Set up the system to wipe and rerun ootb
7. Cancel a wipe
8. Perform a deinstallation
9. Update the system for recently added hardware (admithw)
10. Check system health (checkhealth)
11. Load network configuration
134 System Deinstallation
Setting
To cancel the process at anytime, press CTRL+C.
Value
57600
8
None
1
Xon/Xoff