Step 2: Installing The Wa22 - Intermec CK30 Installation Manual

Installing the WA22
Before you perform this step, choose a location for the WA22 based on these
guidelines:
• Place the WA22 horizontally on a desk or counter, or mount it
vertically on a wall with the included mounting bracket.
• Mount the WA22 as high as possible (at about two-thirds of the floor-to-
ceiling distance), close to the area where the CK30s will be used.
• Keep the WA22 clear of metal surfaces like beams or girders, which may
decrease the radio range.
• Keep large quantities of paper products from blocking the line-of-sight
between the WA22 and the CK30s, as these products will absorb the radio
signals and make communications unreliable.
Get these items from the Accessories box:
• MobileLAN power bridge and AC power cord
• 2 Ethernet cables (Or, your own cables if you need longer than 3.05 m
[10 ft])
• 2 antennas
On the WA22, remove the antenna port caps and the plastic plug in the
Ethernet port.
10
Attach both antennas to the WA22. Tighten the nut to finger tightness.
If you are not using the mounting bracket, continue with Step 8. To use the
mounting bracket, continue with Step 4.
Insert one shoulder screw into each of the four brass inserts and tighten them
securely.
Brass
inserts
Shoulder
screws
(4 places)
Using the bracket as a template, mark the mounting hole locations on the
mounting surface.
11