Installing The Vehicle Dock - Intermec Trakker Antares 2430 Accessories Manual

To install the 243X vehicle dock
1. Install the vehicle dock.
2. Insert the 243X in the vehicle dock.
3. Connect to power, serial devices, and scanners (powered kit only).
Each step is described in detail in the next sections. If you have the swivel
stand accessory, continue with the instructions on page 7.

Installing the Vehicle Dock

There are two methods to install the vehicle dock:
•
Attach the vehicle dock directly to a mounting surface.
•
Attach the vehicle dock to the swivel stand accessory (Part No.
070803-001) (Optional)
Intermec recommends using the swivel stand accessory. Each method is
described in the following instructions.
To attach the vehicle dock to a mounting surface
1. Choose a mounting location for the vehicle dock. Refer to the
guidelines on page 5.
2. Using the vehicle dock as a template, mark and drill four holes in the
mounting surface.
Screw and nut
(4 places)
2435AI001.eps
6
Mounting
surface
3. Attach the vehicle dock to the mounting surface using appropriate
mounting hardware (up to a #10 screw, not supplied) through each of
the four holes in the vehicle dock and the mounting surface.
To attach the vehicle dock to the swivel stand
1. Attach the vehicle dock to the swivel stand as shown. Use a screw
and nut (included in the swivel stand kit) through each of the four
holes in the vehicle dock and the swivel stand.
Screw and nut
(4 places)
2435AI002.eps
2. Using the swivel stand as a template, mark and drill four holes in the
mounting surface.
3. Attach the swivel stand to a mounting surface using the mounting
hardware provided.
7