Charging The Battery; Removing And Installing The Battery - Intermec CK3R User Manual

Chapter 1 — Using the Computer

Charging the Battery

Removing and Installing the Battery

4
For replacement batteries, contact your Intermec representative.
Make sure you fully charge the AB17, AB18, 1001AB01, or 1001AB02
battery before you use your CK3. You can charge the battery before or
after you install it in the CK3. A fully discharged battery charges in
approximately 4 (AB17, 1001AB01, 1001AB02) to 7 (AB18) hours.
To charge the battery
• Insert the AB17 or AB18 battery into the battery bay of the AD20
single dock, or insert up to four batteries into the AC20 quad
battery charger.
Or,
• Insert the AB17, AB18, 1001AB01, or 1001AB02 battery into the
UMD quad bases model 1002UU04 or 1002UU05 with adapter
cups.
To maximize the time allowed to replace the main battery pack, put
the CK3 in suspend mode before removing the battery pack.
To remove and install the battery
1 Press and hold
CK3 goes into suspend mode.
2 If necessary, disconnect the handstrap from the bottom of the
CK3.
3 Press the battery release tab toward the battery until the battery
releases, and then lift it away from the CK3.
4 Insert the battery into the CK3, and press down on the battery
until it clicks into place.
for about 2 seconds. When you release
CK3R and CK3X Mobile Computer User's Manual
, the